Faac E145s help please

[pm9020]

Hello,

When I power up my cb the display shows the following:
"bo" with two blue led's for 5 seconds.
It then changes to blank screen with two blue led's and one red.

Nothing else appears at all.
Can anyone advise on this? Is it possible to do a reset?

Could the board not have any software on it and do you know if it's possible to have faac look at this? It's a new system which I have just installed and can't figure it out.

Thank you for your help.

[jsw]

Hello,

When I power up my cb the display shows the following:
"bo" with two blue led's for 5 seconds.
It then changes to blank screen with two blue led's and one red.

Nothing else appears at all.
Can anyone advise on this? Is it possible to do a reset?

Could the board not have any software on it and do you know if it's possible to have faac look at this? It's a new system which I have just installed and can't figure it out.

Thank you for your help.

[jsw]

I have exactly the same problem. Got the board replaced but it’s doing exactly the same thing. bo and 2 blues and red error light.
Did you get a solution?
There must be a way to reset the software?

[DesmondVog]

One of the topics is not getting loaded in the help file;
It shows: 404: File or Directory not found error?

Is there anything i can do to check whats wrong?

regards,
Raghu

[aba gate solutions]

you need to wire the connectors first, it cant see any safetys etc.
then you can go through programming using the 'f' key