Thread Rating:
  • 25 Vote(s) - 3.04 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Genius board (FAAC) help
#3
(07-03-2020, 02:38 PM)Kingkelly77 Wrote: Hi forum,

My Genius board has no power going to it. I checked the mains supply in and its live but nothing on the control board. It looks like the board in the back of the box has gone. Does anybody not what part this is? It's not the control board, its the board behind that one.

Thanks
Sam
[Image: 565KFWQ]

Image of the board: https://ibb.co/565KFWQ

Probably a slug on the back of the board. You could remove the board out the cabinet and look on the rear. Ensure the power is off!!!!

Access Control Ltd 
0333 5776227
Reply


Messages In This Thread
Genius board (FAAC) help - by Kingkelly77 - 07-03-2020, 02:38 PM
RE: Genius board (FAAC) help - by JoeF - 17-03-2020, 10:19 AM
RE: Genius board (FAAC) help - by AccessControlLtd - 01-04-2020, 12:26 PM
RE: Genius board (FAAC) help - by JoeF - 02-04-2020, 11:30 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  FAAC 455D - wiring issues? jonah 1 139 Yesterday, 10:13 AM
Last Post: jonah
  FAAC Configure 443Hz remote to open partially, pause and close Ezylryb 3 6,911 11-11-2025, 03:33 PM
Last Post: Prem
  Faac 740D, Open further then limit, not closing emiel 1 6,733 26-08-2025, 02:23 PM
Last Post: Jakedugmore
  FAAC Eq45s , only Leaf A closing with remote Cummil2 1 4,411 13-03-2025, 10:06 AM
Last Post: benbrooks
  FAAC Eq45s , only Leaf A closing with remote Cummil2 1 4,444 13-03-2025, 10:05 AM
Last Post: benbrooks
  FAAC S800 Single swing Gate not responding robhight 0 4,012 18-11-2024, 11:48 AM
Last Post: robhight
  Genius Ja592 - repeated failures john@worldhq.com 0 2,859 22-08-2024, 08:49 AM
Last Post: john@worldhq.com
  FAAC problem dennisoates 0 3,757 30-06-2024, 04:40 PM
Last Post: dennisoates
  Intermittent ‘Stop’ command - FAAC 741 Sliding Gate bwel 3 10,017 22-04-2024, 03:21 PM
Last Post: JoeF
  Faac 415 can't reset from manual to operate mode Stephen Q 1 7,568 18-03-2024, 01:20 PM
Last Post: RXH

Forum Jump:


Users browsing this thread: 1 Guest(s)