Thread Rating:
  • 24 Vote(s) - 3.17 Average
  • 1
  • 2
  • 3
  • 4
  • 5
FAAC 455d electrical interference
#1
When my yard care person uses a gas powered blower on driveway at the gate, the control board gets into a problem state.
So this happens when the gate is held open by a toggle switch (the inside manual opener).
He uses his blower; and upon opening the toggle switch, after time delay, one of the two sides of the gate
doesn't close. It sounds like the actuator for that misbehaving gate sid
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  FAAC Configure 443Hz remote to open partially, pause and close Ezylryb 3 5,285 11-11-2025, 03:33 PM
Last Post: Prem
  Faac 740D, Open further then limit, not closing emiel 1 6,254 26-08-2025, 02:23 PM
Last Post: Jakedugmore
  FAAC Eq45s , only Leaf A closing with remote Cummil2 1 3,981 13-03-2025, 10:06 AM
Last Post: benbrooks
  FAAC Eq45s , only Leaf A closing with remote Cummil2 1 3,888 13-03-2025, 10:05 AM
Last Post: benbrooks
  FAAC S800 Single swing Gate not responding robhight 0 3,699 18-11-2024, 11:48 AM
Last Post: robhight
  FAAC problem dennisoates 0 3,326 30-06-2024, 04:40 PM
Last Post: dennisoates
  Intermittent ‘Stop’ command - FAAC 741 Sliding Gate bwel 3 9,248 22-04-2024, 03:21 PM
Last Post: JoeF
  Faac 415 can't reset from manual to operate mode Stephen Q 1 7,017 18-03-2024, 01:20 PM
Last Post: RXH
  Faac 455d Grantplant 1 7,706 13-11-2023, 11:58 AM
Last Post: Aiden Mitton
  FAAC 740 limited travel LoneStarCycler 0 6,471 24-06-2023, 01:06 AM
Last Post: LoneStarCycler

Forum Jump:


Users browsing this thread: 1 Guest(s)