18-01-2017, 08:37 PM
hi all ive just started out with gate automation could anyone give me a bit of advice
ive been asked to put some beninca kbob motors on a set of gates they have the hinge thread going into some 150mm box section and the pin it swivels on as part of the box section part of the gate when im working out the distance for the bracket i weld to hold the motor do i class my pin centre as the point from the box section usually i would use a standard pin and adjustable eye setup but i dont want to spend time putting them on if i can do with this current set up.any advice would be appreciated thanks.
ive been asked to put some beninca kbob motors on a set of gates they have the hinge thread going into some 150mm box section and the pin it swivels on as part of the box section part of the gate when im working out the distance for the bracket i weld to hold the motor do i class my pin centre as the point from the box section usually i would use a standard pin and adjustable eye setup but i dont want to spend time putting them on if i can do with this current set up.any advice would be appreciated thanks.